Three Phase Duplex Industrial Grade Control Panel with Continuous Level Monitoring
The VIP-XR three phase duplex control panel is designed to be rugged, simple and versatile. One panel handles three voltages and a wide range variety of pump motor amperage requirements by simply field installing overload modules – up to 32 amps each. The VIP-XR operates with a 4-20mA level transmitter which can be configured for either 1 or 2 backup float switches. The VIP-XR features the simple to operate TPC-X controller with an intuitive menu and graphic display.
This product is available to use with our Rapid Set™ mounting system to simplify your control package installation. The durable welded, stainless-steel, white power-coated frame with sunshield protects both operators and controls from the weather.
Features
- Padlockable NEMA 4X fiberglass enclosure, 18 x 16 x 10 inches
- 208, 230 or 460V 3-phase power input
- IEC motor starters with interchangeable overload modules up to 32 FLA
- Pump disconnect/overload reset accessible through inner door
- 22mm Hand-Off-Auto controls on inner door
- Supports 1 or 2 float independent backups
- LED alarm beacon
- White painted steel inner door and backplate
- Single-point power connection
- Tri-voltage stepdown control transformer
TPC-X Controller:
- Simple, intuitive controller operation
- Works with standard 4-20 mA level transmitters
- Easily scalable for different depth ranges
- Configurable display units: ft, in, cm, bar, etc.
- Pump run indicators
- Fault displays, including pump seal fail and overtemperature
- Pump up/down and alternation selection
Specifications
VOLTAGE SUPPLY:
- 208/230/460 VAC 50/60 Hz 3Ø
ENCLOSURE:
- 18 x 16 x 10 inch (45.7 x 40.6 x 25.4 cm) NEMA 4X fiberglass, rated for indoor/outdoor use
INNER DOOR & BACK PLATE:
- White painted steel LOCKING LATCH: (2) thermoplastic, padlockable
TPC-X CONTROLLER:
- Provides pump control sequence, pump selector switch, pump lag delay timer (0-60sec), high water alarm, pump status indication, ETM and cycle count, seal fail inputs, level set points, units of measurement selection, pump up or pump down, and industry standard 4-20mA analog input for level control
FLOAT CONTROL VOLTAGE:
- 12 DC
MOTOR STARTER:
- IEC motor protection switch, IEC motor contactor with disconnect/overload reset mounted through the inner door
PUMP AMPS:
- 0-32 FLA each
ALARM HORN:
- 83-85 decibel rating
FLASHING RED LED ALARM LIGHT 360°
PUMP HAND-OFF-AUTO SWITCHES:
- 22mm mounted on inner door
PUMP RUN LIGHTS:
- green LED, 22mm mounted on inner door
ELAPSED TIME METER:
- mounted on inner door