Single Phase Simplex Demand or Timed Dose Controlled System for Pump Control and System Monitoring
The Power Zone™ Single Phase Simplex panel is designed to control one 115/230V single phase pump in water and sewage installations. The easy to read LCD display provides for simple menu navigation, site setup, and access to critical alarm events, pump run times, and pump cycle counts.
Power Zone control panels are now more versatile than ever! In addition to our float-based models, we have now added the option of continuous level sensing with the new CS4-20 level transmitter. The CS4-20 Level transmitter uses a standard 4-20mA signal to provide continuous level monitoring in level control applications. The transmitter wetted components are designed with non-conductive materials to provide an electrical isolation barrier. It features 22/2 shielded cable with vent tube and is reverse polarity protected.
COMPONENTS
- NEMA 4X enclosure rated for indoor or outdoor use
- Locking latch for added safety
- Controller touch safe housing
- Digital backlit LCD display; 2 lines, 16 characters per line
- (a) Pump Run LEDs, (b) Control Power and Alarm Power LEDs, and (c) Control and Alarm Power Short LEDs
- Menu/Enter & Set/Change buttons for programming and viewing control panel
- Two circuit breakers: one for pump power; another for control and alarm power
- Pump run relay controls pump byswitching electrical lines
- Terminal strip for field wiring of incoming power, floats and pump
- Pedestal (optional) with easy access cover
Features
- Float or 4-20mA continuous level sensing models
- 4-20mA model provides inputs for two float backup
- Digital backlit LCD for easy setup and system monitoring
- Field configurable for Demand or Timed Dose control
- Zero cross over sensing for extended motor relay life
- Exterior touch sensor for alarm silence and test
- Five-year limited warranty on panel
- Two-year limited warranty on 4-20mA transmitters
- UL Listed
Options:
- Auxiliary alarm and redundant off circuitry
- Heavy duty option increases circuit breaker and wire gauge to allow 16-20 amps
- Poly pedestal with access cover
- Float configurations
Specifications
VOLTAGE SUPPLY:
- Pump: 115 VAC or 230 VAC 50/60 Hz 1Ø
- Control/Alarm: 115 VAC 60 Hz 1Ø
ENCLOSURE:
- 10 x 8 x 6 inch (25.4 x 20.3 x 15.2 cm)
- NEMA 4X ultraviolet stabilized thermoplastic rated for indoor/outdoor use
INNER DOOR:
- Molded thermoplastic
LOCKING LATCH:
- Stainless steel, padlockable
FLOAT CONTROL VOLTAGE:
- 115 VAC
MOTOR STARTER:
- Solid state power relay
PUMP AMPS:
- 0-16 Amps, 16-20 Amps
ALARM HORN:
- 83-85 decibel rating
FLASHING RED LED ALARM LIGHT
Downloads
- Power Zone™ Single Phase Simplex Control Panel – Catalog Page
- Power Zone™ Single Phase Simplex Control Panel – Float Model Installation Instructions
- Power Zone™ Single Phase Simplex Control Panel – CS4-20 Level Transmitter Feature Sheet
- Power Zone™ Single Phase Simplex Control Panel – 4-20mA Transmitter Model Installation Instructions
- Power Zone™ Single Phase Simplex Control Panel – Circuit Board Replacement Installation Instructions
